FURMAN M-8S 9 Outlet Rackmount Sequencing Power Conditioner

 M-8S  FURMAN 

 Rackmount Sequencing Power Conditioner 

The Furman Merit M-8S Power Sequencer is a great low-cost AC power solution for any rack mount system.  Install an M-8S in your rack, and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-amp load.

• Power Sequencing - Prevents excessive inrush currents.

• Noise Filtration - Noise filtering to reduce radio frequency and electromagnetic interference.

• Surge Protection - Ensures equipment stays safe.

• 9 Total Outlets - Eight rear panel outlets and one front panel convenience panel outlet.

• 15 Amp Rating - 15 amp rating, with circuit breaker.

• "Protection OK" Indicator - Front panel indicator LEDs for Outlet Banks, Protection OK and Power Status.

• Wall Wart Spacing - Rear outlets have been spaced to accommodate even the bulkiest of wall warts and adapters.

Furman M-8S Features:

• Standard level AC protection and filtering

• Six sequenced rear panel outlets (in 3 groups), two unswitched rear panel outlets, and one front panel unswitched outlet

• Momentary and Maintained sequencing via rear panel terminal block or front panel switch (momentary only)

• All settings and configurations available on rear panel

• Three year limited warranty

Furman M-8S Specifications:

• Maximum Output Current: 15 amps, 120 VAC (Thermal breaker)

• Line Cord: 14AWGx3, 10 feet, black, fixed, NEMA 5-15P plug

• AC Receptacles:

• Convenience Outlet (Front Panel): 1 Un-switched NEMA 15-5R

• Rear Panel Outlets: 2 Un-switched NEMA 5-15R (1 duplex), 6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay)

• Standard level AC Surge Protection: Merit Class (sacrificial)

• Spike Protection Mode: Line to neutral, zero ground leakage

• Max Continuous Operating Voltage: 130V RMS

• Max Clamp Voltage: 500 Volts Peak

• Peak Impulse Current: 12,000 Amps

• Energy Rating (2 X 820¼S): 225 Joules

• AC Filtering: Standard level Pi LCR Filter

• Noise Attenuation: >26dB, 100 Khz to 1 MHz

• Operating Temperature Range: 40°F - 105°F (5°C - 40°C)

• Humidity Range: <90% rH (Relative Humidity)

• Rocker Switch: Front panel, Sequence (ON, OFF)

• Thermal Circuit Breaker: Front panel, push to reset

• Front Panel Indicators: Delay 1, Delay 2, Delay 3, Power, Protection OK

• Rear Panel DIP Switches: 12V Mode On/Off, GND Mode On, Momentary/Maintained

• Potentiometer: Rear panel, time calibration fine tune delay adjust

• Remote Terminal: +5-30VDC In, 12VDC (12mA) Out

• Remote Terminal: Phoenix type 4-Pin Connector with Screw terminals; +12V, STAT, REM, GND (Class 2 Wiring)

• Dimensions (LxDxH): 19" x 8.75" x 1.75"

• Weight: 7 lbs.

• Power Consumption: 5 Watts

• Safety Agency: C/CSA/US

SALE: $451.95 

FREE S&H in continental US (e-mail for international / offshore USA rates)